Imp Jar Pod System Coils Explained

What Coils Does the Imp Jar Pod System Use?

A clear breakdown of the 0.8 ohm mesh coil built into every Imp Jar pod, why mesh suits this device and what e-liquid it is designed for.

0.8 ohmFixed resistance built into every Imp Jar pod
Mesh buildEven heating for consistent flavour
50/50 e-liquidRecommended ratio for this coil type

The short answer

The Imp Jar Pod System uses a single 0.8 ohm mesh coil, built directly into each replacement pod rather than sold as a separate part. This coil is designed for mouth to lung vaping and works best with 50% VG and 50% PG e-liquids.

Browse the Imp Jar Pod System

The Imp Jar Select 10K device and replacement pods. UK made in Maidstone, Kent.

Why mesh coils suit this device

Mesh coils use a flat woven heating element rather than traditional coiled wire, giving a larger, more even surface area for the e-liquid to heat against. This typically produces more consistent flavour and a longer lasting performance compared to older round wire coil designs, which is why mesh has become standard across most modern pod kits.

Why 0.8 ohm specifically

At 0.8 ohm, the coil sits comfortably within the MTL resistance range, ideal for the tighter, more restricted draw the Imp Jar Pod System is built around. This resistance pairs naturally with the 50/50 VG and PG e-liquids recommended for the device.

Wondering which e-liquids pair best with this coil? See our guide on the best e-liquid for the Imp Jar Pod System.

Coil specification at a glance

Spec Detail
Resistance 0.8 ohm
Build type Mesh
Sold as Built into each replacement pod
Recommended liquid 50% VG, 50% PG

Common questions about the coil

Can I buy a different resistance coil for this device?

No, the Imp Jar Pod System uses a single fixed 0.8 ohm mesh coil built into each pod, there is no alternative resistance option available.

Can the coil be replaced separately from the pod?

No, the coil and pod are a single unit, when the coil wears out you replace the whole pod rather than swapping a coil inside it.

Will a thicker e-liquid damage the coil?

A high VG liquid may not wick properly through this coil, which is designed for 50/50 ratios and could shorten its lifespan or cause dry hits.

Part of the Imp Jar Pod System guides hub

This page is part of our complete Imp Jar Pod System guide series. Return to the Imp Jar Pod System Guides Hub for the full topic overview. Browse the related guides below.